Alienware Aurora R13 - Entering the Service Tag in the BIOS Setup Program

5. Install the 2230 solid-state drive or the 2280 solid-state drive in SSD slot one, as applicable.
6. Install the 2230 solid-state drive or the 2280 solid-state drive in SSD slot two, as applicable.
7. Install the single-graphics card.
8. Install the memory module.
9. Install the
front bezel.
10.Install the right-side cover.
11. Install the top cover.
12. Install the
left-side cover.
13. Follow the procedure in After working inside your computer.
Entering the Service Tag in the BIOS setup program
Steps
1. Turn on or restart your computer.
2. Press F2 when the Dell logo is displayed to enter the BIOS setup program.
3. Navigate to the Main tab and enter the Service Tag in the Service Tag Input field.
Next steps
NOTE: Service tag is the alphanumeric identifier located at the back side of your computer.
85