Table 4. System setup options—Advanced menu (continued)
Advanced
Multiple Atom cores
Multiple Atom cores Allows you to configure Multiple Atom cores.
Default: All
Trusted Execution
Trusted Execution Allows you to enable or disable Trusted Execution.
Default: Enabled
Integrated NIC
Integrated NIC Allows you to enable or disable the integrated NIC.
Default: Enabled
SATA/NVME Operation
SATA/NVME Operation Sets the operating mode of the integrated storage device
controller.
Default: RAID on
PCIe Resizable Base Address Register
PCIe Resizable Base Address Register Allows you to enable or disable the Resizable Base Address
Register (BAR) feature.
Default: Disabled
IPv4 HTTP Support
IPv4 HTTP Support Allows you to enable or disable IPv4 HTTP Support.
Default: Disabled
IPv6 HTTP Support
IPv6 HTTP Support Allows you to enable or disable IPv6 HTTP Support.
Default: Disabled
USB Configuration
Front USB Ports Allows you to enable or disable the Front USB ports.
Default: Enabled
Rear USB Ports Allows you to enable or disable the Rear USB ports.
Default: Enabled
Power Options
Wake Up by Integrated LAN Allow the computer to be powered on by special LAN signals.
Default: Disabled
AC Recovery Sets what action the computer takes when power is restored.
Default: Power Off
Deep Sleep Control Allows you to define the controls when Deep Sleep is enabled.
Default: Enabled in S4 and S5
USB Wake Support Allows you to enable the USB devices to wake the system from
Standby.
Default: Enabled
USB PowerShare in S4/S5 state Allows you to charge external devices.
93
To Next Page
Loading...
