WELCOME TO NECTA LINE-SCAN CAMERAS
Before starting using your camera, make sure you follow these basic rules and steps for a safe and effec-
tive use of NECTA .
• Make sure you are using a correct hardware (Section 1.1);
• Check safety and precautions chapter (Section 2.8);
• Access yourUserAreaonwww.alkeria.com and download camera manual and install MaestroUSB3
SDK (Section 1.2);
• Install your camera in your setup (Section 1.3).
Warning
Please do not connect I/O interface yet. Use the I/O connectors only after
completing the rst start of the camera and after reading Chapter 4 of this
manual.
• Connect and start the camera for the rst time (Section 1.4);
• Perform a camera calibration (Section 8.2).
Tip
Check the videos in your User Area about camera calibration.
IMPORTANT NOTES
• Make sure you check the information about NECTA Player and its functions in Chapter 9;
• Deeply check our manual and code samples: most of common operations and options available
are described there;
• Remember that youcanalways reach our support team through your User Area on www.alkeria.com
or emailing support@alkeria.com
Warning
NEVER try to power the camera through the I/O interface. Our cameras are
self powered through USB3.
To Next Page
Loading...