Allen-Bradley PowerFlex 755 User Manual

Rockwell Automation Publication MOTION-UM003K-EN-P - January 2019 143
Configure Integrated Motion Using a PowerFlex 527 Drive Chapter 6
3. Choose a Feedback Configuration type.
Table 43
compares the feedback type and loop type.
4. Choose an Application Type, if applicable.
Table 42 - Compare the Axis Configuration Types for the Drives
Axis Type PowerFlex 527
Position Loop (P) Yes
Velocity Loop (V) Yes
Torque Loop (T) No
Feedback Only (N) No
Frequency Control (F) Yes
Table 43 - Compare the Feedback Type and Loop Type
Feedback Type Axis Type PowerFlex 527
Motor Feedback Position Loop (P), Velocity Loop (V),Torque Loop (T) No
Motor Feedback Position Loop (P), Velocity Loop (V) Yes
Load Feedback
Position Loop (P), Velocity Loop (V),Torque Loop (T) No
Dual Feedback Position Loop (P) No
Dual Integrator Position Loop (P) No
Master Feedback Feedback Only (N) No
No Feedback
Frequency Control (F) Yes
No Feedback Velocity Loop (V) No
TIP Application Type defines the servo loop configuration automatically. These
combinations determine how the calculations are made, which can reduce
the need to perform an Autotune or a Manual Tune.

Allen-Bradley PowerFlex 755 Specifications

General

Category	AC Drive
Amperage	2.2…1470 A
Output Voltage	0 to Input Voltage
Output Current	2.2…1470 A
Enclosure	IP20, IP30, IP54
Communications	EtherNet/IP, ControlNet, DeviceNet
I/O	Digital, Analog, Encoder, Relay
Safety	Safe Speed Monitor
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overload, Short Circuit, Ground Fault, Overtemperature
Operating Temperature	-10°C to 50°C (14°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5…95% noncondensing
Altitude	Up to 1000m (3300ft) without derating
Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Control Method	Sensorless Vector