ALLFILL VF110-E - Setting up the Cascade Feeder

Setting Up the Cascade Feeder
The Cascade Vibration selection of the Setup Vibration screen (see previous) provides
access to selections that define how the cascade pan feeds product to the primary pan. You
can use the following to define how the cascade feeder distributes product to the primary
vibrating pan.
1. If necessary, press SETUP from the MAIN screen.
2. Press SETUP VIBRATION, then CASCADE VIBRATION.
Model VF110-E Touch Screen Control Panel Users Manual
13
AFI Publication 1910817 ● Issue: 1 ● August 2017
3. Press CASCADE VIB ON DELAY to prevent the cascade feeder from dispensing
product at the secondary vibrator for the entered selection. This entry can be used to
allow the pan to become evenly distributed with product at the start of filling.
4. The BULK VIBRATION setting selects the rate of vibration during the first, bulk stage
fill of the cascade feeder. Use the DRIBBLE VIBRATION setting for the subsequent
stage of cascade operation.
5. When done, press PRIMARY VIB to return to the primary Setup Vibration screen.