Chapter 9: Dial-in User Configuration
100 Section I: Using the Menus Interface
Modifying a Dial-
in User
This procedure explains how to modify an existing Dial-in User on the
switch. For each user, you may change the password and the VLAN
assignment. However, you cannot change the user name.
To modify a Dial-in user, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type D to select
Dial-in User Configuration.
The Dial-in User Configuration Menu is shown in Figure 22 on page
97.
3. Type type M to select Modify User.
The following prompt is displayed:
Enter dial-in user name >
4. Type the name of the dial-in user that you want to modify.
The following prompt is displayed:
Enter dial-in user password >
5. Type the password of the dial-in user. You may type in a new
password or the existing password.
The following prompt is displayed:
Enter dial-in user dynamic VLAN ID >
6. Type the VID of the dial-in user. You may type in a new VID or the
existing VID.
7. Type Q to select Quit to previous menu and save your changes.
To Next Page
Loading...
