Allied Telesis AT-S79 - Deleting a Trap Receiver; Modifying a Trap Receiver

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 139
d. Enter a previously defined community name followed by Enter. See
“Adding an SNMP Community” on page 128.
The Trap Receiver Configuration Menu is redrawn with the new trap
displayed.
5. Type Q to select Quit to previous menu and save your changes.
Deleting a Trap
Receiver
To delete a trap receiver, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. From the SNMP Configuration Menu, type T to select Trap Receiver
Configuration Menu.
The Trap Receiver Configuration Menu is displayed in Figure 31 on
page 133.
4. Type D to select Delete Trap Receiver.
The following prompt is displayed:
Enter entry number>
a. Enter a trap number between 1 and 10. Then press Enter.
The Trap Receiver Configuration Menu is updated.
5. Type Q to select Quit to previous menu and save your changes.
Modifying a Trap
Receiver
To modify a trap receiver, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. From the SNMP Configuration Menu, type T to select Trap Receiver
Configuration Menu.