AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 209
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 34.
2. From the Basic Switch Configuration Menu, type U to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
41.
3. Type R to select RADIUS Server Configuration.
The RADIUS Server Configuration Menu is shown in Figure 51.
Figure 51. RADIUS Server Configuration Menu
4. Type I to select Set Server IP.
The following prompt is displayed:
Enter IP address for RADIUS server>
5. Type the IP address of the RADIUS server and press Enter.
6. Type P to select UDP Port Number.
The following prompt is displayed:
Enter port number>
User Interface Configuration -> RADIUS Server Configuration
Server IP Address : 0.0.0.0
Server Port : 1812
Shared Secret :
----------------------- <COMMAND> -----------------------------
Set Server [I]P
Set UDP [P]ort Number
Set Shared Se[c]ret
[Q]uit to previous menu
Command>
To Next Page
Loading...
