Allied Telesis AT-S79 - Figure 32. Trap Receiver Configuration Menu

Chapter 11: Simple Network Management Protocol (SNMP)
138 Section I: Using the Menus Interface
The Trap Receiver Configuration Menu is displayed in Figure 31.
Figure 32. Trap Receiver Configuration Menu
4. Type A to select Add New Trap Receiver.
The following prompt is displayed:
Enter entry number>
a. Type a trap number between 1 and 10. Then press Enter.
The following prompt is displayed:
Enter trap version (1/2) >
b. Type the trap version and then press Enter. Select 1 for SNMP
version 1 or select 2 for SNMP version 2vc.
The following prompt is displayed:
Enter IP address for trap receiver>
c. Enter an IP address in the xxx.xxx.xxx.xxx format.
The following prompt is displayed:
Enter community name >
SNMP Configuration Menu -> Trap Receiver Configuration Menu
Authentication Trap:Enabled
No. Version IP Address Community
---- ------- ------------- --------------
1 V1 167.114.71.1 Tech Com
2 V2c 167.114.71.2 Tech Com
3 V2c 167.114.71.3 System Test
4
5
6
7
8
9
10
------------------------------<COMMAND>-------------------------------
[A]dd New Trap Receiver [D]elete Trap Receiver
[M]odify Trap Entry [E]nable/Disable Authentication Trap
[Q]uit to previous menu
Command>