Allied Telesis AT-S79 - Figure 50. MAC Based Access Control Configuration Menu

Chapter 17: 802.1x Port-based Network Access Control
204 Section I: Using the Menus Interface
The MAC Based Access Control Configuration Menu is shown in
Figure 50.
Figure 50. MAC Based Access Control Configuration Menu
5. Type P to select Port No.
The following prompt is displayed:
Enter port number>
6. Enter the number of the port on the switch you want to configure. You
can configure only one port at a time.
The MAC Based Access Control Configuration Menu is updated with
the current settings of the selected port.
7. Configure the 802.1x settings for the port. A change to a parameter
takes affect immediately on the port. The settings are described here:
NAS ID
This parameter assigns an 802.1x identifier to the switch that applies
to all ports. The NAS ID can be up to sixteen characters. Valid
characters are 0 to 9, a to z, and A to Z. Spaces are allowed.
Specifying an NAS ID is optional.
Advanced Switch Configuration -> MAC Based Access Control Configuration Menu
Port No: 1 Port Control: Forced Authorized Authentication Method: Local
Transmit Period: 30 sec Max Request: 2 Quiet Period: 60 sec
Re-auth Period : 3600 sec Re-auth Status: Disabled
Supplicant MAC Addr MAC Control Auth Status
------------------- ----------- -----------
----------------------- <COMMAND> ------------------------------------
[N]AS ID [M]aximum Request [I]nitialize Port
[N]ext Page Q[u]iet Period [G]uest VLAN ID
Pre[v]ious Page R[e]-auth Period Auth [M]ode
[P]ort No Re-[a]uth Status Aut[h]entication Method
Port [C]ontrol Multi-h[o]st [Q]uit to previous Page
[T]ransmission Period
Command>