AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 135
The Host Configuration Menu is updated.
5. Type Q to select Quit to previous menu and save your changes.
Modifying an
Host Entry
To modify an entry from the Host Community Menu, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 28 on page
128.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 29 on page 129.
3. From the SNMP Configuration Menu, type H to select Host
Configuration.
The Host Configuration Menu is displayed in Figure 31 on page 133.
4. Type M to select Modify Host Entry.
The following prompt is displayed:
Enter entry number>
a. Enter a number between 1 and 10. Then press enter.
The following prompt is displayed:
Choose which to be modified (I/C/B)>
Note
In the prompt above, I represents the IP address, C represents
the community name, and B represents both the IP address and the
community name.
b. Select I to change the IP address.
The following prompt is displayed:
Enter IP address for host>
c. Type the IP address for the host in the format xxx.xxx.xxx.xxx.
Then press Enter.
d. Select C to change the community name.
To Next Page
Loading...
