AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 97
Configuring a Dial-in User
The procedures in this section describe how to create, delete, and modify
dial-in users. See the following procedures:
“Adding a Dial-in User” on page 97
“Deleting a Dial-in User” on page 98
“Modifying a Dial-in User” on page 100
Adding a Dial-in
User
For each dial-in user, you must assign a user name, password, and VLAN.
To add a dial-in user, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type D to select
Dial-in User Configuration.
The Dial-in User Configuration Menu is shown in Figure 22.
Figure 22. Dial-in User Configuration Menu
Advanced Switch Configuration -> Dial-in User Configuration Menu
User Name Password Dynamic VLAN
----------------- ----------------------- ------------------
Jenny ***** 2
Jill ******* 2
Ellen ***** 3
MaryAnn ****** 3
Tom ***** 3
Sam ***** 1
-------------------------------<COMMAND>------------------------------
[N]ext Page [D]elete User
[P]revious Page [M]odify User
[A]dd User [Q]uit to previous menu
Command>
To Next Page
Loading...
