AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 93
Disabling Port Mirroring
To disable port mirroring, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type M to select Port
Mirroring Configuration.
The Port Mirroring Menu is shown in Figure 21 on page 91.
3. Type E to select Enable/Disable Port Mirroring.
The following prompt is displayed:
Enable or Disable monitoring (E/D)>
4. Type D to disable port mirroring.
The port that was functioning as the mirroring port can now be used as
a normal networking port.
5. Type Q to select Quit to previous menu and save your changes.
To Next Page
Loading...
