AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 181
3. Type I to select Set Ingress.
The following prompt is displayed:
Set Bandwidth Control-> Enter port number>
4. Type a port number. Then press Enter.
The following prompt is displayed if you select port 12:
Enable or Disable Ingress Bandwidth Control for port 12
(E/D)>
5. Type E to enable ingress or D to disable ingress on a port.
6. Type Q to select Quit to previous menu and save your changes.
Setting Ingress
DLF Status
To enable or disable DLF ingress status on a switch, perform the following
procedure.
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type B to select
Bandwidth Control.
The Advanced Switch Configuration Menu is shown in Figure 44 on
page 179.
3. Type D to select Set DLF Ingress Status.
The following prompt is displayed:
Enable or Disable DLF Bandwidth Control for all ports
(E/D)>
4. Type E to enable DLF Bandwidth Control or D to disable DLF
Bandwidth Control.
5. Type Q to select Quit to previous menu and save your changes.
To Next Page
Loading...
