0120028-J0 Rev F
16
5� Site Evaluation and Pre-Installation
5�1 Installation Locators
Equipment is suitable for installation in one or more of the following locations:
• Network Telecommunication Facilities
• Locations where the NEC applies
• OSP
5�2 Pre-Installation Requirements
5� 2 �1 Primary Protection
The eLimiter+ has built-in second level surge protection in compliance with the GR-1089 requirement. Primary pro-
tection must be in place at the customer site.
5�3 Packing Materials
All Alpha products are shipped in rugged boxes and suspended via solid inserts to minimize shock that may oc-
cur during transportation. Packaging assemblies and methods are tested to International Safe Transit Association
standards.
5�3�1 Returns for Service
Save the original shipping container. If the product needs to be returned for service, it should be packaged in its
original shipping container. If the original container is unavailable, make sure that the product is packed with at least
three inches of shock-absorbing material to prevent shipping damage.
Alpha Technologies is not responsible for damage caused by improper packaging of returned products.
5�4 Check for Damage
Before unpacking the product, note any damage to the shipping container. Unpack the product and inspect the
exterior for damage. If any damage is observed, contact the carrier immediately.
Continue the inspection for any internal damage. In the unlikely event of internal damage, inform the carrier and con-
tact Alpha Technologies for advice on the impact of any damage.
5�5 General Receipt of Shipment
The inventory included with your shipment depends on the options you have ordered. The options are clearly
marked on the shipping container labels and bill of materials.
Call Alpha Technologies if you have any questions before you proceed: 1 888 462-7487.
To Next Page
Loading...
Need help?
General