37
0120028-J0 Rev F
6�12 LPS Alarms
The LPS and channel alarms are indicated on the Line Powering System > View Live Status interface with a red
border Figure 34.
Figure 34 — LPS alarm highlighting
Figure 35 — Viewing LPS alarms
LPS alarms report in Alarms > View Live Status (Figure 35), Alarms > Configure Alarms (Figure 36), and Event
Log interfaces.
The Controller “rolls up” LPS alarm events. For example, if there are multiple LPS devices and one of them on one
channel reports Vout Low, the alarm “LPS Channel Vout Low” is raised.
If a channel on a different LPS, also reports the same alarm, another distinct alarm will not be raised – it is “rolled up”
into a single event.
To Next Page
Loading...