41
0120028-J0 Rev F
6�12 �2 Controller Reset
Soft Reset
A soft reset enables the Controller to finish saving files to flash memory before a power down or restart.
When pressed momentarily, the unit beeps twice then resets. The front-panel LEDs illuminate temporarily, but will
extinguish after the system has finished its 15-second self-test.
Soft/IP
reset
Hard reset
IP Address Reset
This reset allows local access; for example, with a laptop and a standard
network crossover cable. To reset the IP address, press and hold the Soft/IP
reset button for three seconds.
The CXCI+ beeps three times, the IP is reset to 10�10�10�201 and the DHCP
is disabled. The settings are saved and the unit is reset.
Hard Reset
An unmarked, hard reset button is also located on the front panel on the
CXCI+, it is the unmarked button on the left front.
This reset button can be used to restart the microprocessor if the soft reset
button fails.
CAUTION!
During reset, the Controller may need to run a defragmentation cycle. Cycling of the
LEDs on the controller front panel indicate that defragmentation is in progress. A full
defragmentation can take up to 20 minutes to perform. DO NOT POWER DOWN the Con-
troller during this time.
CAUTION!
Use of hard reset may cause loss of data.
To Next Page
Loading...
Need help?
General