Software Setup
NHA80945 04/2017 37
Configuring the Communication Parameters
Overview
The parameters are described according to the graphic display terminal. These settings are also possible
from commissioning software.
Access
The parameters are accessible in the [Communication] COM, [CANopen] CnO- menu.
[CANopen Address] AdCo
About This Parameter
This parameter defines the address of the drive on the network. This parameter is taken into account after
a power cycle.
Access
This is a read/write parameter.
The parameter number is 6051
Possible Settings
The table presents the parameter settings:
Settings Code Value Description
[OFF]
[1 to 127]
OFF
1...127
0
1...127
CANopen address is not assigned.
CANopen address is assigned.
Factory setting: OFF
To Next Page
Loading...
