Ametek LS1 Series - Displayed Units on the Handheld Remote Control

LS User Manual 23
6.6 DISPLAYED UNITS ON HANDHELD REMOTE CONTROL
The handheld remote control can display the load and extension values in 1 of 3 combinations:
N and mm
kgf and mm
lbf and in
To change the displayed units, press ZERO key 2 times when “Lloyd Instruments” is displayed im-
medialtely after the machine is switched on
The displayed units will change in sequence:
If N and mm is displayed, these will change to show kgf and mm
If kgf and mm is displayed, these will change to show lbf and in
If lbf and in is displayed, these will change to show N and mm