LS User Manual 39
9.8 SETTING A PASSWORD
Pressing the Change Password Soft Key brings up the following display:
Change or create the password
CHRIS
Pressing BkSp Soft Key deletes one character at a time starting from the right hand end of the
password.
Pressing the Clear All Soft Key deletes all the characters.
The Alphanumeric keys add new characters to the password the ENTER key accepts the password
as displayed.
If the password displayed is blank then there will be no password protection.
The password limits access to the edit test setup menus. If a password has been set this password
will be required before any parameter of any test setup can be edited. The selection and running of
previously dened test setups is not affected.
9.9 SAFETY LOAD LIMIT
The Safety limit is intended as an extra protection against accidental injury. It applies when the JOG
keys are pressed or during return when the crosshead is moving down. Entering a high value for this
option will reduce the level of safety provided and should only be done to over come nuisance errors
caused by high friction in some accessories.
9.10 SLOW JOG SPEED
The Slow Jog setting allows the user to specify the speed that the crosshead will move when the
slow JOG keys are pressed.
9.11 SETTING FOR PRINTER
The Data Format Soft Key toggles between Printer and ASCII (ASCII for when a DATALOGGER is
to be used).
9.12 GRIP PROTECTION SETTINGS
The Grip Protection setting is an additional load limit, which can be used to protect grips or acces-
sories that are being used. The test will be stopped if the value of load exceeds the Grip Protection
setting during a test.
9.13 CURRENT LANGUAGE
Pressing the Current Language soft key allows the user to select the language to be used from the
list of languages supported by the machine. The chosen language will be used for all information
presented to the user, including information output to a printer.
BkSp Clear All
To Next Page
Loading...
