50 LS User Manual
11.0 CLEANING AND MAINTENANCE
11.1 CLEANING EXTERNAL FINISH AND TRIM
The nish and appearance of your machine can be maintained by regular cleaning with a damp cloth
containing a small amount of mild detergent. The machine should be turned OFF and disconnected
from the mains supply whilst cleaning is taking place. Strong proprietary cleaners and petroleum
based or other solvents should not be used.
CAUTION: Take care to use only a damp cloth. NO moisture must ever be allowed to get
into the machine. Wipe the machine dry before connecting to the mains supply and
restarting.
11.2 MAINTENANCE
In normal use and conditions, your machine should be serviced and calibrated annually by LLOYD
INSTRUMENTS or one of their appointed agents. There are no user serviceable or adjustable parts
within the machine, therefore service and calibration should only ever be undertaken by engineers
trained for the task.
If the machine is being used in a particularly arduous way or under extreme conditions, your ap-
pointed service agent may recommend more frequent calibration/service.
18 Unexpected reset code 40
19 Unexpected reset code 80
20 Unexpected software reset code 100
21 Unexpected software reset code 101
22 Unexpected software reset code 102
23 Unexpected software reset code 103
24 Unexpected software reset code 104
25 Unexpected software reset code 105
26 Software reset code 106 (000000)
27 Loadcell calibration due
28 System Hardware Error
29 Drive System Error
30 Crosshead on nal limit switch
31 Accessory Connected/Disconnected
32 Load/Speed Rating Exceeded
33 Extensiometer Range Exceeded
34 Stiffness Enabled Wrong Loadcell Fitted
35 Cell Overload Tension
36 Cell Overload Compression
37 Stop key pressed
38 Loadcell Reference Error
To Next Page
Loading...
Need help?
General
