Ametek mocon Dansensor MAP Mix ProVectus - Page 35

Dansensor® MAP Mix Provectus EN User Guide 33
P/N 300862-K
11/2019
26 Error Import/Export: no data found User information
27 Error Import/Export: corrupted data User information
28 Error Import/Export failed User information
32 Error Unknown error from STM Contact service
33 Error Error from STM Contact service
34 Error Error from STM Contact service
35 Error Internal communication error Contact service
36 Error Internal communication error Contact service
58 Error Fan speed too low, check if fan is functional Contact service
59 Error Error in fan parameters, running fan at full speed. Contact service
60 Error Temperature sensor not calibrated. Device
temperature may not be valid.
Check cooling/
filters
If error persists,
contact service
61 Error Cannot start mixer: invalid mixer parameters. User information
62 Warning Mixer is not calibrated Contact service
for calibration
63 Error Mixer could not reach requested flow Check that the
inlet pressure is
OK
(2-10 bar)
71 Error Cannot establish connection to external mixer User information
72 Error Data log network dump failed: cannot connect to
server
Check LAN
connection
73 Error Data log network dump failed: connection to server
was lost
Check LAN
connection
74 Error Data log network dump failed: no ACK received Check LAN
connection
75 Error Data log network dump failed: wrong ACK received Check LAN
connection
76 Error Mixer low pressure alarm on gas input X User information
77 Error Error from slave mixer User information
78 Error Configured flow over maximum possible User information
80 Error Cannot start mixer: flow under minimum User information
81 Error Pressure alarm on gas input X User information
No. Type Message User action