Ametek ta7000R User Manual

PN T900-013, Rev A
Next, to initiate automatic operation of the ta7000R, press the Run key again.
The upper-left corner of the screen will change to display “Run Mode” to indi-
cate the ta7000R is now performing a Cycle Run. “Idle” is now displayed in the
lower-left corner of the screen (Figure 2-8.1).
Working From the Run Mode Screen
After the ta7000R has warmed up to normal operating temperature, press the
Run key to view the Main Menu screen. The upper-left corner of the screen
will display “Idle Mode” to indicate the ta7000R is not measuring or perform-
ing any other actions.
The ta7000R will display the time left (in seconds) for the current cycle in the
Status Bar, next to Run Mode (Figure 2-8.2).At the end of each cycle the re-
sults will be updated and displayed in the Main Window (Figure 2-8.1).
Figure 2-7.3.
Main Menu screen.
CO
=
H
2
=
Idle Mode
12:34:25
Run Cool Calib Blank Page
Figure 2-8.1.
Run Mode screen.
Run Mode 235 12:55:30
CO
= 12.7
H
2
= 16.1
Idle Page
Cycle Run
Installation and Start-Up | 2-17

Ametek ta7000R Specifications

General

Brand	Ametek
Model	ta7000R
Category	Laboratory Equipment
Language	English