PN T900-013, Rev A
Working From the System Settings Screen
The rst Page screen (System Settings screen, Figure 3-4) is for general con-
guration settings.
Setting the Clock
This screen allows you to set the ta7000R Time and Date. Use the Up/Down
arrow keys to select Clock, then press the Edit key. Move the cursor ( ‘
*
‘ ) to
the rst number and use the Up/Down arrow keys to make changes. The time
format is DD-MMM-YY HH:MM:SS, where:
- DD is the numeric day
- MMM is the rst three letters of the month
- YY is the last two digits of the year
- HH is the hour in 24 hour time format
- MM is the minute
- SS is the seconds
When nished press the Esc key and the time will be set.
Printing Chromatograms
Select this feature to print chromatograms after each run. Use the Up/Down
arrow keys to select Print Chromatograms and then press the Toggle key to
toggle this feature On/O (enabled/disabled).
Enabling Enhanced Detection Limit (EDL) Analysis Mode
Using the Enhanced Detection Limit mode will help eliminate noise that oc-
curs from run-to-run. This parameter will toggle Enhanced Detection Limit
mode On/O. Use the arrow keys select EDL mode and then press the Toggle
key to toggle the mode On/O. EDL mode averages the last eight (8) samples
point-by-point to get an average sample and chromatogram.
Printing Diagnostic Information
The Diagnostic Print key appears when setting the clock. Press the Print key
from this page to print a complete report of all system settings, calibration set-
tings, temperatures and status, and the chromatogram from the last run of the
ta7000R. This is a system diagnostic tool which can be used to troubleshoot
problems with the ta7000R.
3-6 | ta7000R Gas Purity Monitor
To Next Page
Loading...
Need help?
General
