Ametek ta7000R User Manual

PN T900-013, Rev A
Troubleshooting
Error Messages are viewed and acknowledged on the System Settings screen.
When the Status LED on the front panel is RED it indicates that there are
system errors or the status of the ta7000R Gas Purity Monitor has changed. The
System Status screen displays error messages that the system has encoun-
tered. From the System Settings screen, check the System Errors area for
error messages (alarms) that have been detected by the ta7000R Monitor.
Error Messages
This section lists the Error messages that can be triggered by the system, to
alert you to potential or impending problems with the ta7000R. Descriptions
of the Errors, along with possible trigger conditions, and corrective action to
take to correct the Errors, are also included.
Error Condition / Description / Corrective Action
Chassis Controller Error
Internal electronics failure.
Corrective Action:
Contact AMETEK Service or qualied service representative for troubleshooting assistance.
Detector Controller Error
Internal electronics failure.
Corrective Action:
Contact AMETEK Service or qualied service representative for troubleshooting assistance.
Figure 4-1.
System Settings screen.
System Settings
Idle Mode 12:34:25
Edit Print Page
Clock: 10-Jan-03 12:34:25
Print Chromatograms:
EDL mode:
+
+
*
-------------------- System Errors --------------------
Ver. 2.70
Troubleshooting | 4-1

Ametek ta7000R Specifications

General

Brand	Ametek
Model	ta7000R
Category	Laboratory Equipment
Language	English