PN T900-013, Rev A
Use Proper Attire
Equipment is hot, user should wear protective groves while handling the
equipment.
All electrical connections, adjustments, or servicing of the ta7000R should be
performed only by properly trained and qualied personnel.
All electrical connections, materials, and methods (plus all safety standards
and procedures) must be made in compliance with local wiring regulations
and electrical code for the hazardous area, as specied by the Owner Com-
pany, local electrical-inspection authority, and National/EU regulations.
Follow appropriate regulatory and/or company procedures to lock out the
ta7000R while working on its electronics.
Verify ground continuity of all equipment before applying power. For electri-
cal shock protection, the ta7000R must be operated from a grounded power
source that has a securely connected protective ground contact.
The ta7000R must have electrical power, instrument air pressure, αnd appli-
cable gas pressure for proper operation. If proper electrical power, instrument
air pressure, or applicable gas pressure are not supplied, the ta7000R could be
permanently damaged and the warranty will be void.
Operators should not attempt to repair the ta7000R. Any repairs made without
rst consulting AMETEK Customer Service shall void the manufacturer’s
warranty
Use Proper Wiring
To avoid re hazards, use only the wiring specied in the “Installation and
Start-Up” chapter of this manual.
Avoid Electrical Overload
To avoid electrical shock or re hazard, do not apply a voltage to a terminal
that is outside the range specied for that terminal.
Contents | vii
To Next Page
Loading...
