3.6. Lubrication and Maintenance Operations
After 20 hours of operation (daily)
3.6.1. Engine oil level check
Pull out oil dipstick (1), wipe it.•
Put it back down to the stop and pull out again to read the •
oil level.
Note
If the engine was running, wait ca 3 minutes until oil descends
into engine sump.
Note
Low division mark L shows lowest possible oil level, high di-•
vision mark H (High) shows the highest level.
The amount of oil between Low and High marks is 1,5 l •
(1,6 U.S. Quart).
Following the rell, please wait ca 3 minutes until oil de-•
scends into the sump, then check the level.
Do NOT run the engine unless there is
correct oil level in the engine.
Maintain the level between the division
lines stamped on the dipstick.
Rell the oil of identical type as stated in
Section 3.2.1.
Replenish oil through ller-neck with the ller plug removed •
(2).