3.6. Lubrication and Maintenance Operations
Following 250 hours of operation (3 months)
3.6.11. Engine oil exchange
Prepare an appropriate vessel of ca 9 l (2,4 galUS) capacity.•
Remove drain plug (1) and let the oil ow out.•
Check the drain plug gasket, replace if damaged. •
Check the thread and clean seating face for gasket. •
Reinstall the plug. Torque is 50 Nm (37 ft lb).•
Clean the surface round oil lter head. Remove the lter.•
Clean seating face for lter gasket.•
When draining the oil temperature shall
not be over 60°C (140°F) – risk of burn.