Ammann AV 70 X - Emergency Stop of the Machine; How to Stop the Machine and Its Engine; Machine Parking

73AV 70 X
OPERATION MANUAL
2.7.3. Emergency stop of the Machine
Apply this in the event of failure where the engine is unable to be shut o via the key in the ignition box,
or through shifting the travel controls (1) to position (0)!
How to switch ON:
Press emergency brake button (8) and the Machine will brake, engine will turn OFF and the acoustic alarm will start.
On cluster (25) the indicator lamps for seat switch, parking brake, recharging will light up, and lubrication indicator lamp will start to
icker.
How to switch OFF:
Turn the press button in the direction of arrows and the acoustic alarm will get turned OFF.
On cluster (25) the parking brake indicator lamp and neutral indicator lamp will remain ON.
Shift travel controls (1) to neutral (N) position, the Machine can be started again in this position.
Do NOT use emergency brake to stop or switch OFF the engine during normal operation of the
Machine!
2.7.4. How to stop the Machine and its engine
Press button (7) on travel control (1) to switch OFF vibration, indicator lamp on cluster (25) will go OFF.
Stop the Machine through shifting travel controls (1) to neutral (N) position.
Use accelerator control (13) to adjust idle engine speed.
Switch over the key in the ignition box (12) to “0“ position, and tilt back the ignition box lid to close it.
Do not stop hot engine instantly but keep it running idle for 3 minutes. The engine and turbocharger
will get cooled down slowly and evenly!
Travel controls (1) shall be always in neutral (N) position!
Switch OFF the battery disconnector during Machine shutdown!
2.7.5. Machine parking
Shut down the Machine on at and solid surface at a point with no potential of natural hazard (landslides, possible ooding, etc.)
Following the engine stop, before leaving the Machine, please disconnect its battery disconnector (51).
Clean the Machine to remove dirt (scrapers and drums).
Make overall inspection of the Machine and repair any defects that have occurred during operation.
Lock the Machine covers and its cabin.
Do NOT stop hot engine instantly, but instead let it idle for 3 minutes. The engine and turbocharger will
cool down slowly and evenly!