Ammann AV 70 X - Page 30

24 AV 70 X
2.1. Major Safety Precautions
Following the alarm an operator may start the Machine only •
when all the workers have left the danger area. At close
(blind) workplaces it will be possible to start the operation
only after a time necessary to leave danger area has elap-
sed.
During Machine operation observe safety regulations, make
•
no action that might endanger work safety, give full attenti-
on to Machine steering.
Respect Code of Practice or instructions of a person respon-
•
sible.
When rolling (traversing) the Machine within a workplace
•
adapt your speed to a terrain condition, to a work perfor-
med and weather conditions. Watch permanently the clea-
rance so to avoid collision with any obstruction.
Upon completion or stop of the Machine operation during
•
which driver leaves the Machine, he/she must make mea-
sures against unauthorized use of the Machine or against
spontaneous starting the engine. Remove key from the ig-
nition box, disconnect the wiring via disconnector, lock the
cabin, engine bonnet.
When shutting down the Machine on roads the measures
•
under regulations eective on roads shall be taken.
When operation is completed, park the Machine at a proper
•
parking place (at, bearing area) so as not to endanger Ma-
chine stability, not to make the Machine interfere with trac
roads, not to expose the Machine to falling objects (rock),
and where the Machine is safe against any natural disaster
of other kind (oods, landslides, etc.).
In the event that the machine has no cab or when the win-
•
dows are open, the operator must wear ear protectors.
When working with the Machine is ended all the defects, da-
•
mage to the Machine and any repairs made shall be written
down in the Operation Logbook. Upon immediate changing
of drivers the driver will be liable to call attention of chan-
ging driver to any facts identied.
Driver shall use personal protective equipment (PPE) – work
•
clothing, safety shoes, the clothing shall not be too loose,
impaired, hair protected with proper head piece. During
maintenance (lubrication, relling, replacement of working
media) your hands must be protected with proper gloves.
Use proper mus when using Machine with no cabin or with
open windows.
Driver shall maintain the Machine equipped with ttings
•
and outt required.
Maintain the Machine free of oil dirt or ammable materials.
•
Keep the drive’s stand, foot rests and runner areas clean.
When the Machine comes into contact with high voltage
•
observe the following principles:
try to leave with the Machine a hazardous zone
-
do not leave driver’s stand
-
give warning to others to keep o and not touch the
-
Machine.
To keep the machine free of oil contaminants and inam-
•
mable materials.