Ampcontrol IPM V2 - 4.3 Mechanical Installation Information

Ampcontrol Pty Ltd – ABN 28 000 915 542
IPM V2 USER MANUAL
IPM2B003 Revision 15 – MAY/18
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
Page 17 of 83
APPROVED FOR EXTERNAL DISTRIBUTION – PROPERTY OF AMPCONTROL PTY LTD – NOT TO BE REPRODUCED IN PART
4.3 Mechanical Installation Information
4.3.1 IPM V2 Integrated Protection Relay
The IPM relay is a panel mounted relay that requires a 135mm x 135mm square cut out.
There are four mounting brackets and four M5 screws that are supplied with the relay. These brackets
slide into the side of the relay after it has been inserted into the cut out. The screws are inserted into
the bracket and tightened to secure the IPM to the panel.
Figure 4.1: IPM Relay Dimensions