Ampcontrol IPM V2 - Setup Procedure for Snore Function

Ampcontrol Pty Ltd – ABN 28 000 915 542
IPM V2 USER MANUAL
IPM2B003 Revision 15 – MAY/18
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
Page 44 of 83
APPROVED FOR EXTERNAL DISTRIBUTION – PROPERTY OF AMPCONTROL PTY LTD – NOT TO BE REPRODUCED IN PART
11.2 Setup Procedure for Snore Function
Setup of the Snore Function is done by settings throughout the menu structure. The additional settings
required to enable the Snore Function include:
 Start Mode must be set to „Snore‟
 The Snore Delay parameter must not be set to none
 The „Under Current‟ trip level must not be set to none
 The AUX External Digital input must be active
11.2.1 Relay Snore Mode Starting Procedure
When the „Snore‟ start mode is selected, the relay can be initially started from different sources:
 Start key on facia, if and only if the aux input is closed,
 External start button, if and only if the aux input is closed.
Each operation of the „Start‟ key will cause the relay to proceed through a power-on sequence
regardless of the status of the snore function.
11.2.2 Relay Stop Procedure
The relay will be stopped whenever the Stop key or the external Stop is actioned – regardless of the
Snore process. This will reset the snore delay timer.
If the AUX input opens at any time during operation in Snore mode, then a start is required to restart the
snore function. The Message „Snore – Need Aux‟ will be displayed on the screen when in Snore mode
with the AUX open. This will reset the snore delay timer.