L0118G
1-2
Sensit 3 Food vendors can be configured for Health &
Safety protection by selection
. All vendors shipped
from the factory with FOOD firmware installed will be
configured fir Health & Safety protection of all
selections.
If any selections are exempted, it is the operator’s
responsibility to mark those unprotected selections
with the included yellow labels (or other means), and
to instruct route persons on loading restrictions.
FAILURE TO DO SO COULD RESULT IN AN
UNACCEPTABLE HEALTH RISK TO THE
CUSTOMER.
1.3 ENERGY STAR SYSTEM
These Models have been specifically designed to
consume less energy while maintaining your products
at the desired delivery temperature. They differ from
the VCB/VCF Models in that they use different
refrigeration components and front window heating
systems.
The EPA test requirements are very detailed and
specific, and as a result machines only meet these
exacting specifications when they are configured for
maximum capacities of 12oz. cans and operated at
colder than normal temperature settings. Please
contact AMS for further information.
1.4 MODEL IDENTIFICATION
When requesting service, replacement parts or
technical assistance, please copy the information
found on the vendor Serial Plate (Refer to Figure 1.1).
It is attached inside the door near the upper right
corner of the window and is visible from the outside.
The information contained on this plate is necessary
to determine what parts, kits, or maintenance should
be applied to your specific model.
Figure 1.1 Typical Serial Plate
Model Number Breakdown (Refer to Figure 1.1)
AMS
39 – 6 40
Manufacturer Cabinet Trays Selections
Width
Example: AMS39-640 means it is an Automated
Merchandising Systems snack vendor, 39” wide, with
six (6) trays and forty (40) selections for different
products.
*The dash number is dropped for Food, Bottle and
Milk vendors and is replaced with “VCB” or “VCF”.
ENERGY STAR Model Numbers Breakdown
(Refer to Figure 1.1)
AMS
LB9
Manufacturer Low ‘B’-Bottle/Food* Cabinet
Temp ‘C’ – Combo Width
** Bottle/Food Machines have Health & Safety
Software while Combo machines do not.
Serial Numbering System (Refer to Figure 1.1)
1-0902-0275
Built Year Month Sequence
On all AMS serial numbers, the first digit identifies
where a merchandiser was manufactured. Those
merchandisers built in the U.S. start with the number
1. Those merchandisers built in Mexico start with the
number 2.
The next two digits identify the year of manufacture.
These numbers are 09 (for 2009) and so forth.
The next two digits identify the month. The first month
of the year is 01 and the last month is 12.
The last four digits identify the number assigned to
each merchandiser during assembly. Numbering
starts with 0000 and continues through 9999,
whereupon these four digits start over.
An example of the numbering system in use is as
follows:
1-0902-1156
This merchandiser was manufactured at the
Kearneysville, W.V. plant in 2009, in February, and
was the 1156
th
merchandiser manufactured.
To Next Page
Loading...
