AMX DXLink User Manual

NetLinx Programming of DXLink Transmitters and Receivers
79
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
NetLinx Programming of DXLink Transmitters
and Receivers
Overview
Important: Before DXLink TXs and RXs can receive any NetLinx SEND_COMMANDs, the DIP
switch’s #3 Toggle must be set to ON or the devices will not be accessible from a NetLinx control
system.
The DXLink Transmitters and Receivers recognize a select number of SEND_COMMANDs and
CHANNELs.
Receiver Video SEND_COMMANDs – page 81
Receiver Audio SEND_COMMANDs – page 84
Transmitter Video SEND_COMMANDs – page 85
Transmitter Audio SEND_COMMANDs – page 90
IR SEND_COMMANDs and CHANNELs – page 91
SERIAL SEND_COMMANDs – page 95
Common DXLink Transmitter / Receiver SEND_COMMANDs – page 97
DXLink System SEND_COMMANDs – page 98
SEND_STRING Escape Sequences – page 99
Note: For a listing of all supported Telnet commands, see page 111.
Device Numbering and Ports
Each DXLink Transmitter and Receiver has its own Device Number (which is assigned when the unit is
bound to a Master) and the following ports.
Transmitters and Receivers (Modules)
Port 1 – Serial
Port 2 – Not used
Port 3 – IR TX
Port 4 – IR RX
Port 5 – USB (not supported at time of publication; will be supported in a future firmware upgrade)
Port 6 – Video/Audio Output
Port 7 – Video/Audio Input
Port 8 (Multi-Format TX only) – Analog Video Input
Transmitters (Wallplate TX and Decor Wallplate TX)
Port 1 – Serial
Port 2 – Not used
Port 3 – Not used
Port 4 – Not used
Port 5 – USB (not supported at time of publication; will be supported in a future firmware upgrade)
Port 6 – Video/Audio Output
Port 7 – Video/Audio Input
Port 8 – Analog Video Input
For an example, see the NetLinx Studio illustration in FIG. 39 below.

AMX DXLink Specifications

General

Brand	AMX
Model	DXLink
Category	Receiver
Language	English