Section 6 Performance test system
6-2
6.1 Required instruments
The following table shows the instruments of the performance test system.
ManufactureNomenclature
Swept frequency synthesizer
two Synthesized signal generators
Power meter
Power sensor
Power meter
Power sensor
Power meter
Power sensor
Adapter (K female to K female)
Programmable attenuator
Microwave channel selector
Spectrum analyzer
Signal source
AM/FM test source
two 3 dB attenuators
Four-point junction pad
Lowpass filter
Lowpass filter with fc 2 GHz
50 ohms terminator
IBM-PC/AT compatible
GPIB interface board
Model number
6769B
MG3633A
ML4803A
MA4701A
ML4803A
MA4705A
ML2437A
MA2444A
K222B
MN63A
MN74A
MS2602A
MG443B
11715A
41KC-3
MA1612A
Lowpass filter
GPIB-PC2/2A
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Anritsu
Hewlett Packard
Anritsu
Anritsu
Anritsu
National Instruments Corp.
Note
MS2665C only
MS2665C only
MS2667, MS2668C only
MS2667, MS2668C only
6.2 Required software
Please consult APCS (Anritsu customer service center) for confirmation of software requirements.
Performance test software of MS2665C/MS2667C/MS2668C spectrum analyzer.