Anritsu MS2665C - Checking Items after Assembling Cabinet

Section 2 MS2665C
2-26
(20) Write the compensation value of adjusted IF-Gain 1 and IF-Gain 2 to the spectrum analyzer’s Flash Memory with
Flash Memory writing command “CDW” from personal computer. For example :
CMD > MENTE P2110 ON
CMD > CD40 1, 0
CMD > CD41 1, 3
CMD > CD40 2, 0
CMD > CD41 2, 17
CMD > CD40 3, 0
CMD > CD41 3, 30
CMD > CDW
, where
line 1 makes the spectrum analyzer maintenance mode ON.
<CD40 n, m> is IF-Gain 1 setting statement. “n” is a mixer harmonic order number. “m” is a compensation value in
procedure (9), (14), (19) (0 to 255 integer).
Similarly, <CD41 n, l> is IF-Gain 2 setting statement. “l” is the compensation value (0 to 255 integer).
2.2.6 Assembling cabinet
Refer to 2.3.1.
2.2.7 Checking items after assembling cabinet
After switching the power on, check for the following faults.
(1) No burning smell and/or smoke.
(2) Fan rotates
(3) No strange sounds.
After checking the above items, make sure the original defect has been repaired.