MS20xxC UG PN: 10580-00305 Rev. J C-1
Appendix C — Error Messages
C-1 Introduction
This appendix provides a list of information and error messages that could be displayed on
the VNA Master. If any error condition persists, then contact your local Anritsu Service
Center.
C-2 Reset Options
You can reset your VNA Master to Factory Defaults or use a Master Reset to return to the
FULL Factory Default condition from the menu system or from the Off condition.
Reset Via Instrument Menus
From the VNA Master menu system, press the Shift key, then the System (8) key to open the
System menu. Then press the System Options soft key to open the System Options menu.
Then press the Reset soft key to open the Reset menu (refer to the Reset menu in Chapter 5 of
the VNA Measurement Guide (listed in Appendix A). From the Reset menu, press either the
Factory Defaults soft key or the Master Reset soft key.
Reset from OFF Condition
You can also reset the VNA Master by turning it Off and then restarting under one of the
following conditions:
Factory Defaults Reset:
Hold the Esc button while pressing the On/Off button. Continue holding the Esc button until
the Anritsu splash screen appears. You can then release the button. The VNA Master starts
up with Factory Default settings (refer to section “Reset Menu” on page 6-11). Throughout
this appendix, this sequence is abbreviated as Factory Defaults (Esc+On).
Master Reset:
Hold the 8 key in the number keypad (also referred to as the System (8) key) while pressing
the On/Off button. Continue holding the 8 key until the Anritsu splash screen appears. You
can then release the key. The VNA Master starts up in FULL Factory Default condition (refer
to section “Reset Menu” on page 6-11). Throughout this appendix, this sequence is
abbreviated as Master Reset (System+On).
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
