5-5 File Menu File Management
5-8 PN: 10580-00305 Rev. J MS20xxC UG
5-5 File Menu
Key Sequence: File
Save Measurement As: Press this soft key (submenu key) to save the
current setup with a user defined filename. The default filename is changed
using the Save menu. To change the default filename, type in a new filename
with the number keyboard and press Enter. After a few seconds, the screen
returns to File menu. Press the Save Measurement As key again and the
new file name is used.
Save Measurement: Press this submenu key to display the “Save Menu”
on page 5-9. Measurements can be saved to internal memory or to a USB
flash drive. The saved measurement can be named by using the Save menu
keys. By default, measurements are saved to internal memory in a directory
named /user. The save destination is set with the “Save Location Menu”
on page 5-10.
Save: Press this submenu key to display the “Save Menu” on page 5-9 and
the touch screen keyboard. Measurements can be saved to internal memory
or to a USB flash drive. The saved setup, measurement, or JPEG file can be
named in the Save menu. By default, measurements are saved to internal
memory in a directory named /user. The save destination is set with the
“Save Location Menu” on page 5-10.
Save on Event: Press this submenu key to display the “Save On ... Menu”
on page 5-12. This Save on Event submenu key is displayed only in
Spectrum Analyzer and Interference Analyzer modes (models MS203xC).
Recall Measurement: Press this submenu key to display the “Recall
Menu” on page 5-13. This menu is for recalling measurements from internal
memory or from a USB flash drive.
Recall: Press this submenu key to display the “Recall Menu” on page 5-13.
This menu is for recalling measurement or setup data from internal memory
or from a USB flash drive.
Copy: Press this submenu key to display the “Copy Menu” on page 5-14.
The Copy menu is for copying files or folders from internal memory or a USB
flash drive.
Delete: Press this submenu key to display the “Delete Menu” on page 5-15
and a selection box that shows the setup and measurement names and the
type, date, and time that the information was saved. Use the rotary knob or
the Up/Down arrow keys to highlight the file that is to be deleted, and then
press the Delete submenu key, then press Enter. Press the Esc key to
cancel the operation. Note that deleted files cannot be recovered.
Figure 5-6. File Menu
Caution Deleted files cannot be recoverd.
File
Copy
Recall
Recall
Measurement
Recall
Save
On
Event
Save
Save Measurement As
FileName.vna
Save
Measurement
Delete
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
