Anritsu VNA master User Manual

Error Messages C-3 Self Test or Application Self Test Error Messages
MS20xxC UG PN: 10580-00305 Rev. J C-5
If any of the subtests shows FAILED, then check that the battery level is adequate for
operation or that temperature is within acceptable limits. Reset to factory defaults with
either Factory Defaults (Esc+On), or Master Reset (System+On).
Application Self Test Results Window — SPA
Caution
Use of Master Reset (System+On), will erase all user saved setups and
measurement traces and will return the VNA Master to a full Factory Default
condition. If the error persists, then contact your Anritsu Service Center.
Figure C-3. Application Self Test Results Window (Spectrum Analyzer mode)
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

Anritsu VNA master Specifications

General

Brand	Anritsu
Model	VNA master
Category	Measuring Instruments
Language	English