System Operations 6-12 Power On Self Test
MS20xxC UG PN: 10580-00305 Rev. J 6-13
6-12 Power On Self Test
At power On, the VNA Master runs through a series of quick checks to ensure that the system
is functioning properly.
From the “System Menu”, the System Self Test (“Self Test” on page 6-4) runs a series of tests
that are related to the instrument itself. The Application Self Test (“Application Self Test”
on page 6-4) runs a series of tests that are related to the current operating mode of the
instrument.
If the VNA Master is within the specified operating range with a charged battery, and if the
self test fails, then contact your Anritsu Service Center (http://www.anritsu.com/Contact.asp).
To start a self test when the system is already powered up:
1. Press the Shift key and then the System (8) key.
2. Press the Self Test soft key (submenu key). The Self Test results are displayed.
3. Press Esc to continue.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
