MS20xxC UG PN: 10580-00305 Rev. J 6-1
Chapter 6 — System Operations
6-1 Introduction
This chapter describes the VNA Master system operations.
• “System Menu Group Overview” on page 6-2
• “System Menu” on page 6-4
• “Preset Menu” on page 6-12
• “Power On Self Test” on page 6-13
• “Updating the VNA Master Firmware” on page 6-14
The other menus (Sweep, Measure, Trace, and Limit) are described in the Measurement
Guides that are listed in Appendix A.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
