Anybus CompactCom M40 User Manual

Appendix B: Backward Compatibility 73 (114)
Attribute 30-series 40-series Change/Action/Comment
#7, Record Data Mode See Comment I&M Record data transparent mode (bit 1) is
replaced with the IM_Options command in the
Network PROFINET IO object (0Eh).
If this bit is 0 in the current implementation, no
action is needed
#13, I&M Profile ID Used for all APIs Only used for
“non-zero” APIs
In the 40-series, this attribute is only read for
submodules belonging to a “non-zero” API (e.g.
PROFIdrive profile). Constant values (F600h,
Generic Device and 0004h, Communication
Module) are used for submodules belonging to
API 0.
In the 30-series this parameter is used for all
API:s.
#14, I&M Profile
Specific Type
Used for all APIs Only used for
“non-zero” APIs
In the 40-series, this attribute is only read for
submodules belonging to a “non-zero API” (e.g.
PROFIdrive profile). Constant values (F600h,
Generic Device and 0004h, Communication
Module) are used for submodules belonging to
API 0.
In the 30-series this parameter is used for all
API:s.
#15, I&M Version Available Removed Attribute removed in the 40-series. The Anybus
CompactCom will never request this attribute.
The host application cannot influence the I&M
implemented by the Anybus CompactCom.
16, I&M Supported Available Removed Attribute removed in the 40-series. The Anybus
CompactCom will never request this attribute.
The host application cannot influence the I&M
supported by the Anybus CompactCom.
#20, Interface
description
Available Removed Attribute removed in the 40-series. The Anybus
CompactCom will never request this attribute.
#21, Module ID
Assignment Mode
Available Removed Attribute removed in the 40-series (Incremental
Module Identification removed in the 40-series).
The Anybus CompactCom will never request
this attribute.
#22, System Contact Available Removed Attribute removed in the 40-series. The Anybus
CompactCom will never request this attribute.
System Contact can now only be reached from
the network via SNMP (sysContact). Also see
SNMP MIB-II, p. 77.
#23, PROFIenergy
functionality
Available Removed Attribute removed in the 40-series. The Anybus
CompactCom will never request this attribute.
PROFIenergy is now enabled by the
application having implemented the Energy
Control Object (F0h).
Anybus
®
CompactCom
™
M40 Hardware Design Guide HMSI-216-126 EN 2.6

Anybus CompactCom M40 Specifications

General

Brand	Anybus
Model	CompactCom M40
Category	Conference System
Language	English