55
5
Press CANCEL to accept the changes and return to the idle screen
Set Terminal to Integrated Mode
1
Press the FUNC key
2
Key in 2 and press ENTER
3
Type in Access Code 0240 and press ENTER
4
The Terminal ID will display on the screen, press ENTER
5
At INTERFACE TYPE, press the F2 touchscreen button to scroll to
PCEFTPOS then press ENTER
6
At ETHERNET SETTINGS, press the F2 touchscreen button to scroll to
SKIP and press ENTER
7
Press CANCEL to complete Interface change and return to the main
ANZ screen
Configuring Cable Type – USB Cable
1
Press the FUNC key
2
Key in 11112227 and press ENTER
3
Terminal displays ‘CONFIGURE TERMINAL COMMS?’, press ENTER
To Next Page
Loading...
