Apollo Thunderbolt Software Manual Installation & Setup 14
Installation & Setup
The UAD Powered Plug-Ins installer places all the software necessary to configure and
use Apollo and UAD plug-ins onto the computer’s startup drive. For hardware installation
notes and wiring diagrams, refer to the Apollo Hardware Manuals.
Getting Started Videos
Helpful videos are available to guide you through the installation process:
• www.uaudio.com/support/videos
Software Updates
The most recent UAD Powered Plug-Ins software version is always recommended so you'll
have access to the latest UAD plug-ins and stability updates. The most recent software is
available at the UA website: www.uaudio.com/downloads
Firmware Updates
For optimum results, always update the firmware if prompted by the software. Follow the
onscreen instructions to complete the process before attempting to use the software.
Preparation
Important: The computer must meet the system requirements listed in this
chapter.
Close all open files and applications before starting the software installation procedure.
The installer requires a restart after installation.
If you are updating to a newer version of Apollo software or installing additional UAD
devices, it is not necessary to remove the previous UAD software or hardware from the
system.
Automatic Authorization
If the hardware was previously registered, when the computer restarts the UAD Meter &
Control Panel automatically opens and UAD plug-ins are automatically authorized in the
background.
Offline Authorization
To authorize a UAD system that is not connected to the Internet, see the UAD System
Manual.
Technical Assistance
If you need help, see the Technical Support page.
To Next Page
Loading...
Need help?
General
