Apollo Thunderbolt Software Manual Console Reference 90
Flex Routing
By default, Apollo’s input channels are routed to the monitor outputs only. However,
Apollo’s inputs can be optionally routed to any available Apollo hardware output. A
maximum of eight channel output route assignments are available for each connected
Apollo rack model. This feature is available with Apollo rack models only (Flex Routing is
unavailable with Apollo Twin).
Important: If an output is in use by Flex Routing, it is no longer available to be
assigned as an output within the DAW. The Flex channel output(s) route overrides
the DAW output channels assigned to the same hardware output(s).
Multiple input signals cannot be merged to the same output(s) with Flex Routing
because this feature is not a mix bus. However, the cue mix buses can be used for this
purpose.
Note: Flex Routing is unavailable at sample rates of 176.4 kHz and 192 kHz.
Output Route Display
The Output Route display is located above the each channel’s main
input mix controls, as shown at right. The active output assignment is
displayed here. Clicking the display opens the Output Route window.
Output Route Popover
The Output Route popover window is where the hardware output assignment for the input
channel can be changed.
The Output Route popover
Output Route Display
Previous/Next Channel
Available Output Routes
Mirror to Monitor Button
(orange color = mirrored)
Close Window
Scroll Bar
Selected Hardware
Output Route
(blue)
Routes
Available
Count
Console Default Input Name
To Next Page
Loading...
Need help?
General
