Apollo Thunderbolt Software Manual Console Settings 140
Hardware Settings Panel
The Hardware panel is where Apollo’s system-level audio interface I/O settings such as
sample rate, clock source, and output reference levels are configured. These settings are
used by DAW applications when they are configured to use Apollo as the audio interface.
Even when Console is not open, these settings are stored by the Apollo drivers for use by
other host applications.
The Hardware panel as displayed with multiple Apollo devices
Sample Rate & Clock Settings
Behavior and control of these two settings depend on the operating environment:
Without a DAW – Sample Rate and Clock Source settings define the active sample rate
and clock source for Apollo when a DAW is not used (when Console is the only host
application).
With a DAW – These settings are usually changed within the DAW application’s audio
preferences.
Tip: These settings can also be viewed and changed via Console’s Info Bar.
To Next Page
Loading...
Need help?
General
