Apollo Thunderbolt Software Manual Multi-Unit Cascading 198
Multi-Unit Monitor Outputs
When multi-unit cascading, all units share the same monitor mix bus. The monitoring
speaker system (including ALT monitors, if configured) must be connected to the monitor
outputs of the monitor unit only.
Note: When changing the monitor unit designation, the monitor speakers must be
physically connected to the new monitor unit to hear the monitor outputs.
Monitor Outputs on Expander Units
When multi-unit cascading, the monitor outputs of all expander units are available as
additional line outputs via the I/O Matrix panel within the Console Settings window. In
this configuration, the monitor outputs of the expander units are not affected by the
Monitor Level knob.
Multi-Unit Headphone Outputs
All headphone outputs for all connected Apollo units (monitor and expander) are
available to output the monitor or cue mix buses via the Cue Outputs Popover.
Multi-Unit Cue Outputs
Cue mix buses can be routed to physical outputs (line, ADAT, etc) on the monitor unit
only. However, cues mix buses can be sent to any available headphone output via the
Cue Outputs Popover.
Multi-Unit Monitor Control
Monitor Knobs
The monitor knob on the front panel of expander units (except Apollo Twin, as below),
and its surrounding green LED indicator ring, are disabled. To adjust the monitor output
level, the front panel monitor knob on the monitor unit (or the monitor level controls in
Console or the Console Recall plug-in) must be used.
Apollo Twin Remote
When Apollo Twin is connected in a multi-unit system, its monitor knob mirrors that of
the monitor unit for volume and mute control. This feature offers convenient desktop
control of the monitor and ALT speakers.
To Next Page
Loading...
Need help?
General
