Apollo Thunderbolt Software Manual Working With Apollo 34
How To Route Any DAW Output Into Console’s Virtual Inputs
To route a DAW output signal into Console
for Realtime UAD Processing, simply assign
any Console virtual channel (or channel
pair, when the DAW source is stereo) as the
output device for any DAW track, bus, or
output. That DAW output signal then appears
in the associated virtual input channel in
Console, and it can be processed or routed
the same as Apollo’s hardware inputs.
At Right: Routing a DAW channel’s
outputs into Console’s virtual inputs
How To Route Any Console Virtual Output Into the DAW
To route a Console output signal into the
DAW so it can be recorded, simply assign
any Console virtual channel (or channel
pair, when the Console source is stereo) as
the input source for any DAW input. That
Console signal can then be recorded or
routed like any hardware input by the DAW.
Tip: This technique can be used to re-
capture and record (bounce) a software
instrument performance that was virtually
routed from the DAW into Console for
Realtime UAD Processing.
At right: Routing Console’s virtual outputs into
the DAW channel’s input. Note that any output
listed here (including Console’s monitor and
auxiliary mix buses) can be used as a DAW
input.
To Next Page
Loading...
Need help?
General
