Applanix LVX - 4.6.3. Position Configuration

29
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO APPLANIX CORPORATION. RELEASE TO THIRD PARTIES OF THIS PUBLICATION OR OF
INFORMATION CONTAINED HEREIN IS PROHIBITED WITHOUT THE PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION. APPLANIX RESERVES THE
RIGHT TO CHANGE THE SPECIFICATIONS AND INFORMATION IN THIS DOCUMENT WITHOUT NOTICE. A RECORD OF THE CHANGES MADE TO THIS
DOCUMENT IS CONTAINED IN THE REVISION HISTORY SHEET. COPYRIGHT © APPLANIX CORPORATION, 2021ALL RIGHTS RESERVED. NO PART OF
THIS PUBLICATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS WITHOUT THE
PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION.
4.6.3. Position Configuration:
Special attention should be taken to select the correct Dynamic Model since it will have
an effect on performance The Dynamic Model selection is based on the LV type:
 Mapping vehicle
 Off-road vehicle
Figure 29: Position Configuration
All other settings should be left as shown in Figure 29.
Once the Dynamic model is selected by clicking the OK button, you will be prompted to
reboot LVX in order to apply changes as indicated on Figure 29.