47
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO APPLANIX CORPORATION. RELEASE TO THIRD PARTIES OF THIS PUBLICATION OR OF
INFORMATION CONTAINED HEREIN IS PROHIBITED WITHOUT THE PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION. APPLANIX RESERVES THE
RIGHT TO CHANGE THE SPECIFICATIONS AND INFORMATION IN THIS DOCUMENT WITHOUT NOTICE. A RECORD OF THE CHANGES MADE TO THIS
DOCUMENT IS CONTAINED IN THE REVISION HISTORY SHEET. COPYRIGHT © APPLANIX CORPORATION, 2021ALL RIGHTS RESERVED. NO PART OF
THIS PUBLICATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS WITHOUT THE
PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION.
5.2.1. Calibration Set-up
1. Select Receiver Configuration, INS from the menu bar to open the INS Configuration
page.
• Click on the General tab to open it
• Enable GAMS by checking the box next to it.
2. Click on the GNSS Lever Arm tab to open it
• Enter 0,0,0 for the X,Y,Z Primary to Secondary GNSS Baseline Vector lever arms
to allow the system to estimate the values.
• Enter a 1-σ (one sigma) value equal to the approximate antenna separation (i.e. if
the antennas are set 2 m apart use 2 m).
To Next Page
Loading...